GreenWorks 2101202 Manual Del Propietário página 19

OPERATION
REmOVINg / REPLACINg STRINg HEAD (See Figure 13.)
1. Line up the spacer hole up with the hole in the gear box.
2. Place a small screw driver or metal rod (Not included) in the spacer hole.
3. Rotate the head clockwise to loosen and remove.
4. Reverse steps 1-3 to reinstall the same string head.
SPACER HOLE
Note: If you put a different model string head on this unit please follow the manufacturer's instructions to
install that head.
mETAL ROD
19
Fig. 13