Black and Decker Powerful Solutions KA400 Manual Del Usuario página 6

ENGLISH
Labels on tools
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. On/off switch
2. Dustbag
3. Dust extraction outlet
4. Sanding base
5. Paper clamp lever
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding sheets (fig. A & B)
Warning! Never use the tool without a sanding sheet or
accessory in place.
Fitting sanding sheets with nylon loops (fig. A)
Warning! Make sure that the tool is switched off and
unplugged.
Press the sheet firmly and evenly onto the sanding

base (4), making sure that the holes in the sheet line up
with the holes in the base.
Fitting regular sanding sheets (fig. B)
Warning! Make sure that the tool is switched off and
unplugged.
Soften the sanding sheet by rubbing its non-abrasive

side over the edge of a worktop.
Press the paper clamp levers (5) upwards to release

them from the retaining grooves and open the paper
clamps (5) by pressing them down.
Place the sheet onto the sanding base (4).

Insert the edge of the sanding sheet into the front paper

clamp (5) as shown.
Press the front paper clamp lever (5) downwards and

locate it in the retaining groove.

While keeping a slight tension on the sheet, insert the

rear edge of the sheet into the rear paper clamp (5).

6
Press the rear paper clamp lever (5) downwards and

locate it in the retaining groove.
Louvre attachment (fig. C) (KA400L only)
With this attachment you can work in crevices and use the
sanding base on both sides.
Locate the front of the louvre attachment (7) onto the

sanding base (4).
Secure it in position with the four screws supplied.

Place a 1/2 sheet to the underside of the louvre base.

Part of it will fold over the front part of the base.
To remove the louvre attachment (7), reverse the

procedure.
Fitting and removing the dustbag (fig. D)
Fit the dustbag (2) over the dust extraction outlet (3).

Slide the dustbag (2) onto the tool and make sure that it

is securely located.
To remove the dustbag (2), pull it to the rear and off the

outlet.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
Injuries caused by touching any rotating/moving parts.

Injuries caused when changing any parts, blades or

accessories.
Injuries caused by prolonged use of a tool. When using

any tool for prolonged periods make sure you take
regular breaks.
Impairment of hearing.

Health hazards caused by breathing dust developed

when using your tool (example:- working with wood,
especially oak, beech and MDF).
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off (fig. E)
To switch the tool on, press the part of the on/off switch

(1) marked 'I'.
To switch the tool off, press the part of the on/off switch

(1) marked '0'.
Emptying the dustbag
The dustbag (2) should be emptied every 10 minutes.

Shake the dustbag (2) to empty the contents
