I COMPANDER HARD (COMPANDER-H), COMPANDER SOFT
(COMPANDER-S)
The hard and soft companders combine the effects of the compressor, expander and limiter.
THRESHOLD
Input Level
0dB
WIDTH
The companders function differently at the following levels:
1
0 dB and higher ..................................Functions as a limiter.
2
Exceeding the threshold ....................Functions as a compressor.
3
Below the threshold and width ..........Functions as an expander.
The hard compander has an expansion ratio of 5:1, while the soft compander has an
expansion ratio of 1.5:1. The expander is essentially turned off when the width is set to
maximum. The compressor has a fixed knee setting of 2.
* The gain is automatically adjusted according to the ratio and threshold values, and can be increased by up to 18 dB.
* The OUT GAIN parameter enables you to compensate for the overall level change caused by the compression and
expansion processes.
Parameter
Range
THRESHOLD (dB)
–54 to 0 (55 points)
1.0:1, 1.1:1, 1.3:1, 1.5:1, 1.7:1, 2.0:1,
RATIO
2.5:1, 3.0:1, 3.5:1, 4.0:1, 5.0:1, 6.0:1,
8.0:1, 10:1, 20:1 (15 points)
ATTACK (ms)
0–120 (121 points)
44.1kHz: 6 ms – 46.0 sec
RELEASE (ms)
48kHz: 5 ms – 42.3 sec (160 points)
OUT GAIN (dB)
–18.0 to 0.0 (181 points)
WIDTH (dB)
1–90 (90 points)
I DE-ESSER
This detects and compresses only the sibilants and other high-frequency consonants of the
vocal.
Parameter
Range
THRESHOLD
–54 to 0 (55 points)
FREQUENCY
1kHz–12.5kHz (45 points)
TYPE
HPF, BPF
Q
10.0–0.10 (41 points)
Description
This determines the level at which compression is
applied.
This determines the amount of compression.
This determines how soon the signal is compressed or
expanded once the compander has been triggered.
This determines how soon the compressor or
expander returns to the normal gain once the trigger
signal level drops below or exceeds the threshold
respectively. The value is expressed as the duration
required for the level to change by 6 dB.
This sets the compander's output signal level.
This determines how far below the threshold
expansion will be applied. The expander is activated
when the level drops below the threshold and width.
Description
Threshold level at which the de-esser effect is applied.
Cutoff frequency of the filter used to detect the high frequencies.
Type of filter used to detect the frequency band.
Q (steepness) of the filter when TYPE is BPF.
Effect Type List
Title
Type
REV-X Hall
REV-X HALL
New reverb algorithm that delivers dense and rich reverberation, smooth decay,
and provides a spaciousness and depth that enhances the original sound.
REV-X Room
REV-X ROOM
Choose from three types depending on your location and needs; REV-X HALL,
REV-X Plate
REV-X PLATE
REV-X ROOM, and REV-X PLATE.
Reverb Hall
REVERB HALL
Concert hall reverberation simulation with gate
Reverb Room
REVERB ROOM
Room reverberation simulation with gate
Reverb Stage
REVERB STAGE
Reverb designed for vocals, with gate
Reverb Plate
REVERB PLATE
Plate reverb simulation with gate
Stereo Reverb
ST REVERB
Stereo reverb
Early Ref.
EARLY REF.
Early reflections without the subsequent reverb
Gate Reverb
GATE REVERB
Gated early reflections
Reverse Gate
REVERSE GATE
Gated reverse early reflections
Mono Delay
MONO DELAY
Simple mono delay
Stereo Delay
STEREO DELAY
Simple stereo delay
Mod.Delay
MOD.DELAY
Simple repeat delay with modulation
Delay LCR
DELAY LCR
3-tap (left, center, right) delay
Echo
ECHO
Stereo delay with crossed left/right feedback
Chorus
CHORUS
Chorus
Flange
FLANGE
Flanger
Proprietary Yamaha effect that produces a richer and more complex modulation
Symphonic
SYMPHONIC
than normal chorus
Phaser
PHASER
16-stage stereo phase shifter
Dyna.Flange
DYNA.FLANGE
Dynamically controlled flanger
Dyna.Phaser
DYNA.PHASER
Dynamically controlled phase shifter
HQ. Pitch
HQ.PITCH
Mono pitch shifter, producing stable results
Dual Pitch
DUAL PITCH
Stereo pitch shifter
Tremolo
TREMOLO
Tremolo
Auto Pan
AUTO PAN
Auto-panner
Rotary
ROTARY
Rotary speaker simulation
Ring Mod.
RING MOD.
Ring modulator
Mod.Filter
MOD.FILTER
Modulated filter
Dyna.Filter
DYNA.FILTER
Dynamically controlled filter
Rev+Chorus
REV+CHORUS
Reverb and chorus in parallel
Rev→Chorus
REV→CHORUS
Reverb and chorus in series
Rev+Flange
REV+FLANGE
Reverb and flanger in parallel
Rev→Flange
REV→FLANGE
Reverb and flanger in series
Rev+Sympho.
REV+SYMPHO.
Reverb and symphonic in parallel
Reverb and symphonic in series
Rev→Sympho. REV→SYMPHO.
Reverb and auto-pan in series
Rev→Pan
REV→PAN
Delay+Er.
DELAY+ER.
Delay and early reflections in parallel
7
Description
Data List