Step 7 Adjust Door Swing; Step 8 Install Grille Panel - Monogram FZIR360NNRH Instrucciones De Instalación

Installation Instructions - Standard Installation

STEP 7 ADJUST DOOR SWING

NOTE: This appliance has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. A 130° door swing is available for standard
installation only. Skip this step if door opening is
satisfactory for your installation situation.
Pin Location
for 90°
Door Swing
• Open the hood to view the top hinge. Note the door
stop pin locations. The pin is factory-installed in the
115° position.
• Close the door. Use pliers to unscrew the door stop
and reinstall in the 90 degree or 130 degree position.
31-1000416 Rev. 0

STEP 8 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
Pin Location
for 130°
Door Swing
Pin Location
as Shipped
for 115°
Door Swing
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel and into
the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
19