Dash Disassembly; Kit Assembly - Metra 99-3012G-LC Instrucciones De Instalación

Dash Disassembly

1. Using a panel removal tool, unsnap
and remove the panel surrounding
the radio (vents above radio
included). (Figure A)
2. Unclip and remove the factory A/C
vents from the radio trim panel.
3. Remove four 7 mm screws to
remove the radio. (Figure B)
Continue to kit assembly
99-3012G-LC
(Figure A)
(Figure B)

Kit Assembly

ISO DIN radio provisions
1. Install factory vents into the
radio trim panel. (Figure A)
2. Install the four included panel clips
onto the appropriate locations of
the radio trim panel.
3. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied.
(Figure B)
4. Slide the aftermarket radio into
radio brackets and secure with
screws supplied with the radio.
(Figure B)
5. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the unit for
operation.
6. Mount the new radio assembly into
the dash, snap-in the radio panel,
and reassemble dash in reverse
order of disassembly. (Figure C)
2
(Figura A)
(Figura B)
(Figura C)