Metra 99-3012G-LC Instrucciones De Instalación página 3

Kit Assembly
Double DIN radio provisions
1. Install factory vents into the
radio trim panel. (Figure A)
2. Install the four included panel clips
onto the appropriate locations of
the radio trim panel.
3. Slide the Double DIN aftermarket
radio into the radio housing
brackets and secure with screws
supplied with the unit. (Figure B)
4. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS. Test the unit for
operation.
5. Mount the new radio assembly into
the dash, snap-in the radio panel,
and reassemble dash in reverse
order of disassembly. (Figure C)
99-3012G-LC
(Figure A)
(Figure B)
(Figure C)
Wire connections to be made
CAUTION: Metra recommends disconnecting the negative battery terminal
before beginning any installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before reconnecting the battery
or cycling the ignition.
Note: Refer to the instructions included with the aftermarket radio
Use Metra's 99-3012G to retain ONSTAR, steering wheel audio controls, or control
of the vehicle customization menu.
Interface harness:
1. Connect the Yellow wire to the radios constant/memory wire.
2. Connect the Red wire to the radios accessory wire (a relay is needed if
connecting more to this wire than just the radio).
3. Connect the Black wire to the radios ground wire.
4. Connect the Blue wire to the radios amp turn on.
5. Connect the White wire to the radios left front (+) speaker wire.
6. Connect the White/Black wire to the radios left front (-) speaker wire.
7. Connect the Gray wire to the radios right front (+) speaker wire.
8. Connect the Gray/Black wire to the radios right front (-) speaker wire.
9. Connect the Green wire to the radios left rear (+) speaker wire.
10. Connect the Green/Black wire to the radios left rear (-) speaker wire.
11. Connect the Purple wire to the radios right rear (+) speaker wire.
12. Connect the Purple/Black wire to the radios right rear (-) speaker wire.
3
.
Continued on back