Operation; Before First Use; Preparing The Tool For Use; Maintenance And Cleaning - Parkside PHP 500 C2 Traducción Del Manual De Instrucciones Origina

Operation

Before first use
Preparing the glue site:
■ Do not use inflammable solvents to clean the
glue site.
■ The ambient temperature and temperature of
the materials to be glued must be not less than
+ 5° C and not warmer than + 50° C.
■ The glue sites must be clean, dry and free of
GB
grease.
MT
♦ Smooth surfaces should be roughened before
gluing.
♦ Warm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.
♦ Screw on the appropriate nozzle

Preparing the tool for use

Working with the mains lead connected:
♦ Connect the mains lead
nection (see Fig. B).
Insert the mains plug into the mains socket.
♦ Fold forward the plastic stand
Stand the device up.
♦ Push a glue stick into the feed channel
♦ Let the device heat up for about 5 minutes.
The device is now ready for use.
Cordless working:
♦ Connect the mains lead
nection .
Insert the mains plug into the mains socket.
♦ Place the glue gun into the charger
♦ Push a glue stick into the feed channel
♦ Let the device heat up for about 5 minutes.
The device is now ready for use.
♦ Repeat the heating-up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.
22
.
to the glue gun con-
.
.
to the charger con-
.
.
Gluing:
♦ Press the feed clamp
glue as required for your work.
♦ Apply the glue in individual dots. Apply in zig-
zags on flexible materials such as fabrics.
♦ Immediately after applying the glue, press the
two materials together for about 30 seconds.
The glued joint can be loaded after about 5
minutes.
♦ When you take a break from work, set the glue
gun down on the plastic stand
charger .
♦ Remove any glue residue with a sharp knife
after cooling. Glued joints can be loosened
again by applying heat.
Switching off the device:
♦ Pull the mains lead out of the mains socket.
Changing the nozzle:
■ Wear protective gloves.
♦ Heat up the device for about 5 minutes.
Change the nozzle
■ Danger of burns!
Touch the nozzle
The nozzle tip is hot!
NOTE
Hold item upright, tip up, to prevent glue from
flowing out.

Maintenance and Cleaning

The glue gun is maintenance-free.
WARNING! Pull the mains lead out of
the mains socket before you clean the
tool. Always keep the device clean and
dry.
■ Do not allow any liquids to enter the tool. Use
a soft cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.
to regulate the flow of
or in the
when it is hot.
only by the heat shield
PHP 500 C2
.