Fuel Information - Solo 468 Manual Del Usario

Fuelling
6. Fuelling
6.1 Safety instructions fuelling
 The handling of fuel requires caution and
consideration. It is imperative that all safety
instructions are observed!
 Smoking or open flame is prohibited.
 Allow engine to cool before re-fueling.
 Fuel may contain solvent-like substances.
Avoid skin and eye contact with mineral
products. Wear gloves while refueling.
Frequently change and clean protective
clothing. Do not inhale fuel vapors.
 Do not spill fuel or oil. In case of spillage,
immediately wipe off the power tool. Do not
allow fuel mix to contact clothing. If fuel mix is
spilled on clothing, change clothing immediately
 Ensure fuel or oil do not contaminate soil
(environmental protection). Always use a
suitable protective soil cover.
 Do not re-fuel in unventilated rooms. Fuel
vapors collect at ground level (danger of
explosion).
 Transport and store fuel and oil only in
approved and clearly marked containers.
Children should have no access to fuel or oil.

6.2 Fuel information

A high performance two-stroke engine operated
with a petrol:oil mixture (petrol + oil = fuel mixture)
or with a special fuel mixture for two-stroke
engines available from specialists powers this
machine.
We recommend the proprietary "Aspen 2-takt"
special fuel mixture. Please observe the special
fuel manufacturer's instructions.
Information on individual mixing of the fuel mixture
The fuel mix must be formed from the following
components:
 Lead-free regular petrol or lead-free super petrol
with a minimum octane number of 92 RON.
 Branded 2-stroke engine oil corresponding to
the standard ISO-L-EGD or JASO FD
Recommendation:
Use the "SOLO Profi 2-stroke engine oil" at a
mixing ratio of oil:petrol of 1:50 (2 %).
Store the fuel mix no longer than 3 weeks.
ENGLISH 6
Mix table for fuel mix:
Oil:petrol ratio = 1:50 (2 %)
Branded 2-stroke engine oil
20 ml
40 ml
100 ml
200 ml
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and avoid
inhaling petrol fumes - health hazard!
6.3 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off.
Carefully clean the area around the filler inlet.
Place the machine with the fuel inlet pointing
upwards. Unscrew the tank lid and fill the fuel
mixture up to the lower edge of the filler neck. Use
a funnel with filter to prevent tank contamination.
After filling the tank replace the tank lid and tighten
firmly.
Petrol
1 l
2 l
5 l
10 l