Dc Current Measurements - koban KMD-14 Instrucciones Operativas

DC CURRENT MEASUREMENTS

CAUTION: Do not make current measurements on the 10A scale
for longer than 30 seconds. Exceeding 30 seconds may cause damage
to the meter and/or the test leads.
1. Insert the black test lead banana plug into the negative (COM) jack.
2. For current measurements up to 2000μA DC, set the function switch to
the μA position and insert the red test lead banana plug into the (μA)
jack.
3. For current measurements up to 200mA DC, set the function switch to
the mA range and insert the red test lead banana plug into the (mA)
jack.
4. For current measurements up to 10A DC, set the function switch to the
A position and insert the red test lead banana plug into the 10A jack.
5. Press the AC/DC button until "DC" appears in the display.
6. Remove power from the circuit under test, then open up the circuit at
the point where you wish to measure current.
7. Touch the black test probe tip to the negative side of the circuit. Touch
the red test probe tip to the positive side of the circuit.
8. Apply power to the circuit.
9. Read the current in the display. The display will indicate the proper
www.grupotemper.com
AUTORANGING MULTIMETER
KMD-14
15