Before Use; Removing/Charging/Inserting The Battery Pack; Checking The Battery Charge Level; Switching The Hammer Function On/Off - Parkside PDSSA 12 A1 Traducción Del Manual De Instrucciones Original

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
NOTE
► The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hour. This guarantees
full battery performance. You can charge the
lithium-ion battery at any time without short-
ening its service life. Interrupting the charging
process does not damage the battery.
■ Never charge the battery pack
bient temperature is below 10°C or above
40°C.
1. To remove the battery pack
button and pull the battery pack
appliance.
2. Insert the battery pack
charger .
3. Insert the mains plug into the socket. The control
LED lights up red.
4. The green charge status indicator LED
cates that the charging process is complete and
the battery pack
5. Insert the battery pack

Checking the battery charge level

If the appliance is switched on, the charge level will
be shown on the battery LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PDSSA 12 A1
from or connect
if the am-
, press the release
out of the
into the high-speed
indi-
is ready.
back into the appliance.
as follows:
Switching the hammer function on/
off
CAUTION!
► Operate the hammer function switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
Switching the hammer function on:
♦ Move the hammer function switch
position to activate the hammer function.
Switching the hammer function off:
♦ Move the hammer function switch
position to deactivate the hammer function.

2-speed gearbox

CAUTION!
► Operate the speed selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
No hammer function
In first gear (speed selector switch
tion: 1)
you can reach a speed of approx. 400 rpm and a
low torque. This setting is suitable for all screwing
jobs.
No hammer function
In second gear (speed selector switch
position: 2)
you can reach a speed of approx. 2200 rpm for
carrying out drilling work.
With hammer function
In first gear (speed selector switch
tion: 1)
you can reach a speed of approx. 600 rpm and a
high torque. This setting is suitable for all screwing
jobs.
only
into the
into the
only
in posi-
in
in posi-
GB │ MT │
43 ■