Required Tools - MRA BMW R1150R Instrucciones De Montaje

Read this manual carefully and check the parts list for completeness before you begin. We recommend that you have
Parts List:

1x Windshield

1x Edge protection strip

2x Clamp sleeve

4x Allen screw M 5 x 35mm
 4x Plastic washer

4x Plastic spacer 10mm

4x Rubber washer 5mm
1. Disassemple the original windshield by removing the four screws with T25 Torx key.
2. Insert the four Allen screws with the plastic washers from the upper side into the holes of the MRA windscreen.
Push the Plastic spacer and the rubber washer from the bottom on the screw. The rubber washer only about
5mm.
3. Put the windshield on the original brackets and mount it by fixing the Allen screws with the 3 mm Allen key.
4. Fit the edge protection strip on the whole rear end of the windshield (not on the adjustable spoiler), and cut it
symmetrically on the left and right side.
5. Slide the clamp sleeves over the ends of the edge protection strip and gently squeeze them tight with the pliers,
ensuring that the strip is clamped on the windshield.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at regular intervals.
Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or spirits to clean the screen as
MRA-Klement GmbH + Siemens Str. 6 + D-79331 Teningen
Thank you for buying a MRA Windshield.
your screen fitted by an authorised workshop.
they will damage it.
I N S T A L L A T I O N M A N U A L
B M W R 1 1 5 0 R
Tel.: +49 7663 9389 0 + Email: info@mra.de

Required Tools:


T 25 Torx key

Allen key 3mm

General-purpose pliers
© by MRA-Klement GmbH – 08/2011