Look 695 I-Pack Manual De Montaje página 11

GB
CoMPLete disMountinG oF tHe Headset
Attention:
The complete dismounting of the LOOK Head Fit 3 headset necessitates the use of special
tools; it is strongly advised to consult your authorized LOOK retailer.
1 / Completely loosen the stem.
2 / Make the stem slide towards the top of the pivot. Remove the rubber caps mounted on the
cache's tube.
3 / Loosen the spacer with the advised tools (see Fig. b in the paragraph "Settings of the head
set) and remove the spacer from the fork pivot.
The pin is then visible. Turn the fork a quarter rotation to align the pin opposite the holes in the
tube.
4 / Remove the pin with a diameter 4 drift punch and remove it on the other side of the tube.
5 / Take the pin out of the fork pivot. Take care to hold the fork so that it does not slide from the
tube and be damaged when falling for once the pin removed, no mechanical stop retains the
fork.
6 / remove the lower 1"1/2 bearing from the fork's cone.
WarninG:
Carbon is a very abrasive material that quickly deteriorates tools. If the pivot tube is too
long, the stem will not press against the specific ring which may entail its floating. If the
pivot is too short, the contact area between the pivot tube and the stem will be too feeble
and the hold of the stem will not be optimal.
iMPortant:
do not lubricate the pivot tube.
use the LooK Head Fit 3 headset supplied with the HsC 7 fork or a headset advised by
LooK.
22
MountinG oF tHe sHiMano di2 routinG
For further information on the installation of the DI2 router, please refer to the manufacturer's
notice.
GB
Trou de passage de gaines
Sheath passage grommet
Connector
Connecteur
Inner connector
Connecteur interne (avec gaine
(with heat retractable sheath) thermo rétractable)
Battery support
Support de batterie
Sheath guide Guide gaines
23