After-Sales Service - Look 695 I-Pack Manual De Montaje

GB
instaLLation oF tHe Front
and rear deraiLLeur
Check that the thread of the rear derailleur
is clean.
This frame is intended to receive a front
derailleur of "to braze" type.
Follow the manufacturer's mounting,
setting and maintenance indications.
ATTENTION: The position of the derailleur
sheaths is the following: The end stop
of the sheath on the right of the tube
corresponds to the cable passage
of the rear derailleur . The end stop
of the sheath on the left of the tube
corresponds to the cable passage of the
front derailleur. It is therefore necessary
to take it into account to cut the correct
length of derailleur sheaths coming from
the handlebars. The length of sheaths
should be sufficient to allow the complete
rotation of the handlebars.
MountinG tHe WHeeLs
Follow the manufacturer's mounting
instructions.
Our fork tabs are made with safety spuds.
Before riding make sure that the wheels
are strongly locked by the quick locking
mechanism.
24
MaintenanCe
Always clean your frame with soap or a mild
detergent and water.
Use a soft cloth. Rinse your frame with water
and dry it with a cloth.
Do not use high pressure cleaning equipment
or abrasive products.
To eliminate tar, use a car-cleaning product.
aFter-saLes serViCe
In spite of the care brought to our
manufacturing, if a defect appears or if
repair is necessary, always contact your
wholesaler with the frame or the fork
together with the warranty card.
WarrantY
Our frames and our forks are guaranteed
five years starting on the date of purchase
against any flaw or manufacturing defect.
The paint, decoration, varnish and everything
concerning the finishing are guaranteed one
year.
To validate your guarantee, 2 solutions:
1) Register on our website
2) Imperatively fill in the two sections
enclosed which the retailer shall complete
and send one of the sections stamped
to LOOK CYCLE INTERNATIONAL, sole
authorized to validate guarantee slips.
This guarantee remains limited to the initial
purchaser and proof of purchase id required
(original bill).
on-line registration is surer and quicker on
www.lookcycle.com
The guarantee concerns the frames for all
flaws or manufacturing defects.
The guarantee applies only if the frame is
assembled in compliance with the above
instructions.
The guarantee does not apply to defects due
to insufficient maintenance or incorrect use.
In the same way the guarantee is null
if the product was subject to technical
modification by the user or if it was repaired,
repainted out of a LOOK authorized repair
centre. Especially do not suppress the safety
lugs of the fork's tabs.
The guarantee does not cover the following
cases:
* Defects caused through negligence or
insufficient maintenance
* Accidents
* Accessory and indirect damages
The assembling, disassembling, labour
hours, packaging and sending expenses
are not covered.
Do not pierce, paint or re-varnish.
Do not leave your frame near a source of
heat.
ATTENTION:
Always inspect your bike before use.
If the tubes of your LOOK frame or your
fork were subject to any damage, bring
the bike to your LOOK retailer for an
inspection.
Acquaint yourself with the laws in force
in the country where you are if you ride at
night. The reflectors are not sufficient and
do not replace lighting.
Always use a helmet
Acquaint yourself with the Highway Code
and respect it.
Beware of road and traffic dangers.
GB
25