GM 23436536 Instrucciones

Chevy Camaro Splash Guard - Rear
Please read instructions thoroughly before starting.
Tools Required
T20 Torx Screw Driver
T15 Torx Screw Driver
Clean Cloth/Rag
Parts Required from Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
M4.2 x 20 Self-Tapping Screw
Alcohol Prep-Wipes
Instruction Sheet
Rear Installation Procedure
Note: Do not use power tools to install splash guard
fasteners
1. Remove tire.
2. Using supplied alcohol prep wipe, clean area where tape
will contact fender.
3. Remove existing fasteners from wheel liner at locations
(A), (B) and (C). See Fig. 1.
4. Place splash guard to vehicle and partially install supplied
M4.2 x 20 screws into locations (A), (B) and (C) to allow
enough room to remove the tape liner. See Fig. 2.
5.
See Fig. 3.
6. Fully tighten screws at locations (A), (B) and (C).
7. Repeat procedure for the other side.
8. Guards can be cleaned with any commercially available
cleaner.
NOTE: Max torque on M4.2 Screw is 3.0 N m
Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
02JN15
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
6
2
1
REVISION
Initial Release - Michael Erickson
EXISTING
SCREWS
IR 02JN15
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
2199739
PART NO.
23436536
FIGURE 1
C
B
A
M4.2 X 20
SCREW
FIGURE 3
23436536
PART NO.
Splash Guard - Rear
SHEET
FIGURE 2
C
B
A
TAPE
LINER
1 3
SHEET OF
1 3
OF