User's Guide; Overall Ventilation Functions - Dantherm HCV 400 Serie Manual De Instrucciones

Overall ventilation functions

Introduction
This section describes how the remote controller can be used to set various parameters and
display the units running condition .
Overall description The HCV units can ventilate your home via three different operation modes . These modes can
be selected according to your wishes . Keep in mind however that legislation may prescribe
minimum levels for air change .
Risk of water damage
Warning
CAUTION
• Never turn off the ventilation unit to save energy as this may cause condensation and
subsequent leaks from the duct system with the risk of water damage .
Caution
Manual ventilation In manual operation mode the HCV 400 will run at the selected ventilation speed until this
level
is changed manually . This operating level can be selected via the control panel or the HRC3
remote controller and HCP10 .
Timer-controlled When set to timer-controlled operation, HCV 400 will automatically adjust the ventilation
operation/ weekly speed according to a predetermined weekly schedule . This can cover ventilation in a normal
program family rhythm depending on whether one is home or out of the house . One of the 11 sched-
ules can be adapted with PC-Tool or remote controller .
Week mode is enabled via the control panel or HRC3 remote controller or HCP10 .
Sensor control
When set to demand controlled operation the unit is adjusted as needed . Using measure-
VOC and RH%
ments from the VOC and/or humidity sensor, the unit adjusts the fan speed according to the
sensor (accessory)
need for air change . A VOC sensor measures the quality of the air .
This operating mode can only be selected if the unit is equipped with at least one of the sen-
sors above .

User's guide

25