Publicidad
Idiomas disponibles
Idiomas disponibles
RES UTILITY PUMP INSTALLATION MANUAL
The RES Electronic Utility Sump Pump is the SMARTEST PUMP IN THE MARKET. The RES is designed to remove water from
basements, yards, marine & recreation and shallow fl ooded areas. Simply connect the RES to a standard garden hose on the
discharge, place the pump in the area to be drained, plug into any standard grounded 115 volt receptacle (do not stand in
or touch the water while plugging the pump in or during use!), and it'll automatically run when water is detected; will
automatically shut off when water is down to 1/8". The RES will then automatically check for water every few minutes.
The Electronic Utility Sump Pump is engineered to move water not warmer than 104°F only. Pump failures due to
mud, tar, cement, wood chips, corrosive material damage, or requests for return following temporary use are not
covered under the manufacturing warranty and will not be exchanged, returned for credit or refund.
Failure to follow these instructions may cause serious bodily injury and/or property damage.
The RES Electronic Utility Sump Pump has
CAUTION
built-in overcurrent protection. This pump
can be left plugged in for several hours in
spot jobs but is not recommended to be used as a continuous
duty sump pump or fountain pump.
OPERATIONS
1. Place pump in water.
2. Connect to power source.
3. Pump will begin pumping immediately.
4. After pumping the water out (to a level of 1/8") the pump
will automatically shut off.
5. Pump will cycle every three (3) minutes, running for only
fi ve (5) seconds. If no water is detected, the pump will
shut off automatically.
6. When water is detected the pump will continue pumping
until the water is pumped out.
THE WATER ACE ELECTRONIC UTILITY SUMP PUMP IS SIMPLE TO CONNECT
Connect a standard 5/8" garden hose to the pump
STEP
threaded discharge.
1
Place the pump into the water to be pumped.
STEP
2
Move away from the area to be pumped, and
STEP
3
while standing on dry ground, plug into a dry and
grounded outlet.
23833A487
23833A487
IMPORTANT INSTRUCTIONS BEFORE INSTALLATION
7. Disconnect pump from power source when not in use for an
extended period of time. This prevents unnecessary wear.
WARNING, risk of electric shock – this pump is
supplied with a grounding conductor and grounding
type attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a
properly grounded, grounding-type receptacle.
1. Power cord must always be plugged into a grounded
receptacle.
2. NEVER place pump in water or remove
from water while the unit is plugged in!
3. Unplug this unit when water is drained and not needed for
a period of time.
Connects to 115 volt
grounded outlet
Electronic Utility
Sump Pump
1
Water Out
(garden hose)
Water In
Publicidad
