24H Rainfall Alarm; Hysteresis - Technoline WS 2816 Manual De Instrucciones

 The wind direction alarm display will be shown.
 Press and hold the SET key for about 2 seconds. The wind direction arrow on the
outside of the compass circle will start flashing with the corresponding compass
direction or degrees reading displayed in the center of the compass.
 Press the ▲UP ARROW key or ▼DOWN ARROW key to move the wind
direction alarm pointer.
 Press the SET key to set a wind direction alarm. A pointer icon will appear inside
of the compass circle to indicate an alarm setting for that wind direction.
 To remove an alarm setting for a wind direction, press the SET key again to
remove the selected wind direction alarm. The arrow icon inside the compass
circle will disappear.
 If more than one wind direction is desired as an alarm setting, Press the ▲UP
ARROW key or ▼DOWN ARROW key to move the wind direction alarm pointer
to the next desired setting.
 Press the SET key to confirm the next wind direction. A pointer icon will appear
inside of the compass circle to indicate an alarm setting for that wind direction.
You can set as many wind direction alarms as you desire.
 Press the ALARM key to confirm the setting. The wind direction arrow will stop
flashing.
 Press the SET key to switch on or off the alarm. The ((())) icon indicates the
alarm is switched on.
 Press the ALARM key to move to the 24h rainfall alarm settings.

24H RAINFALL ALARM

 The 24h rainfall alarm display will be shown.
 Press and hold the SET key for about 2 seconds. The 24h rainfall digit will start
flashing.
 Press the ▲UP ARROW key or ▼DOWN ARROW key to set the 24h rainfall
value. Hold the key in to change the value faster.
 Press the ALARM key to confirm the setting. The digit will stop flashing.
 Press the SET key to switch on or off the alarm. The ((())) icon indicates the
alarm is switched on.
 Press the ALARM key to exit the alarm settings.

HYSTERESIS

59