Publicidad
Brake Control Wiring Harness
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Carefully remove the trim panel
under the dash below the steering
wheel (Fig. 1).
Note: Take care not to damage
the courtesy lamp wires
attached to the inside of the
trim panel.
3. Locate the vehicle's brake
control harness connector behind
the panel removed in step 2. The
connector will be taped to a harness
near the emergency brake pedal and
cantains a connector that mates with the one on the
adapter (Fig. 2).
4. Connect the Brake Control Harness wires to the wires
on the Electric Brake Control (not supplied) in the following
manner by using the butt connectors (provided):
Adapter
Black
White
Red
Blue
Brake Control
Black
White
Red
Blue
Function
12v (+)
Ground (-)
Brake Signal from Vehicle
Brake Power to Trailer
Fig. 1
Fig. 2
Publicidad
