Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. From the rear of the vehicle, open the
tailgate. Locate and remove the two mounting
clips from each tail light assembly (Fig. 1).
3. Carefully pry the taillight assemblies
away from the vehicle to expose the wiring
harness behind. Caution: Take care not to
damage the tail light housing alignment tabs.
4. Beginning on the left (drivers) side,
remove the taillight wire harness connector
from the taillight assembly by pressing on
the connector locking tab and carefully
pulling the connector away from the
housing (Fig. 2).
5. Position the matching T-Connector
harness ends with the yellow and
brown wires between the separated connector and
housing, pressing together firmly until the locking tabs engage.
6. Locate a clean accessible mounting location on the vehicle
near the wiring harness ends within reach of the white wire and
grounding eyelet and drill a 7/64" hole.
Caution: Take care not to drill through the body or any
exposed surface.
7. Mount the White wire using the ground screw and eyelet
provided.
Fig. 1
Fig. 2
Publicidad
