Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Remove the tail light assemblies from each side of the vehicle.
There will be a black connector on the vehicle wiring harness
similar to those found on the T-Connector harness. Slide the red
connector lock aside and disconnect
the vehicle harness from the tail light
assembly taking care not to damage the
locking tab (Fig. 1).
3. Beginning on the left (drivers) side,
carefully pull the vehicle wiring harness
and the rubber grommet out a short
distance. Plug the matching
T-Connector harness end with the yellow wire between the tail light
assembly and the vehicle connector removed in step 2. Secure the
connectors together with the red locking tabs.
4. Using a utility knife, carefully slit the grommet as indicated
(fig. 2) from the hole for the tail light wiring harness to the outside
edge of the grommet. Carefully cut away the tabs that
connect the grommet to the wires.
Caution: Take care not to damage the
vehicle wiring harness while cutting the
grommet.
5. Remove the vehicle Jack storage cover
located inside the rear of the vehicle on the left
(drivers) side trim panel to expose the storage area
behind. It may be necessary to remove the tape
covering the access hole between the jack storage
Fig. 1
Cut Line
Fig. 2
Publicidad
