Descargar Imprimir esta página

Installation Instructions - Valley 30210 Instrucciones De Instalación

Publicidad

T-Connector Wiring Harness

INSTALLATION INSTRUCTIONS

1. Read instructions thoroughly before beginning.
2. Open the rear hatch and remove both of the wiring access
side panels located in the cargo area of the vehicle. Open the
spare tire cargo area. Remove the spare tire retaining cap, tire
jack storage tray, spare tire retaining nut, & spare tire.
3. Beginning on the drivers side, unplug the taillight
connectors, while being careful not to break the locking tabs.
Inspect the connectors for dirt and debris and clean if
necessary. Route the two T-Connector ends containing the
( Red/Brown) & Yellow wires through the opening located near
the bumper in the spare tire storage area under and behind
the trim panel up through to the wiring access side panel area.
Plug the T-Connector ends into the vehicle harness connectors
until they lock into place. Take care not to damage the locking
tabs.
4. Route T-Connector end containing the Green wire across
the spare tire storage area to passanger side. Route the
T-Connector ends containing the (green) wires through the
opening located near the bumper in the spare tire storage area
under and behind the trim panel up through to the wiring
access side panel area. Repeat step 3 for the passanger side,
using the T-Connector containing the Green wire.
5. Locate an appropriate position on the vehicle frame to
attach the White wire that has the ring terminal attached to it.
Drill a 3/32" hole and attach the T-ConnectorsWhite wire with
the ring terminal to the vehicle using the #10 screw provided.
Caution: Do not drill into any exposed surfaces or

Publicidad

loading