Sanus MF209 Manual De Instrucciones página 9

2
Wall Mounting - Solid Concrete
and Concrete Block
2-1
Level wall plate [02] and mark hole locations
2-2
Drill pilot holes as illustrated
2-3
Insert anchors [25]
2-4
Tighten lag bolts [23] only until the washers [24] are pulled fi rmly against the wall plate [02]
[24]
[23]
6901-002129 <02>
CAUTION:

Mount the wall plate [02] directly onto the concrete surface.

Minimum solid concrete thickness: 8 in.

Minimum concrete block size: 8 x 8 x 16 in
NOTE:
NOTE:
[02]
TV will shift 15 cm (6 in.) to the right or left when in the home position.
Consider this when selecting the location of your wall mount.
CAUTION:


CAUTION:
the anchors [25] seat fl ush with the concrete surface.
CAUTION:
bolt. To avoid potential injuries or property damage DO NOT over-tighten
the lag bolts [23].
Fit lag bolt covers [26] over lag bolts [23].
NOTE:
[02]
[24]
For assitance in determining wall plate location, see Height Finder at sanus.com.
Avoid potential personal injuries and property damage!
The MF209 is shown.
For the MF209 only:
To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10 mm
(3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
75 mm
(3 in.)
To avoid potential injuries or property damage be sure
[25]
Improper use could reduce the holding power of the lag
The MF209 is shown.
[23]
[26]
13 mm 10mm
(1/2 in.) (3/8 in.)
.
9