Scan Function; Scan Resume Time; Selective Call - Midland CT3000 Manual De Instrucciones

Scan function

CT3000 has 3 types of scanning:
• TO - Time-Operated scan: everytime a signal is detected, the radio will stop
scanning for a few seconds, then it will start scanning again on the other
frequencies even though the signal is still present.
• CO - Carrier-Operated scan: whenever a signal is detected, the radio will
stop scanning and will resume only after the signal disappears.
• SE - Search scan: the radio will stop scanning once a signal is picked up.
1. To select the desired type of scan, access the radio menu and follow these
steps: MENUFUNC MENUSCN
2. Select the desired parameter.
3. To start scanning press the P3 of menu 2 or the button associated to
SCN function.
4. To invert the scan direction use the main knob.
5. To stop scanning press any key on the front panel or PTT.

Scan resume time

It it possible to change the scan resume time. It goes from 5s up to 15s.
1. Enter the radio menu and follow this path:
MENUFUNC MENUSCT
2. Press the main knob to enter the options
3. Turn it to select the desired level.
4. Confirm your choice by pushing the main knob.

Selective call

You may sometimes want to hear calls from only specific persons or groups.
In this case, use the selective call function. This transceiver is equipped with
CTCSS tones and DCS codes. These selective calls allow you to ignore (not
hear) unwanted calls from other persons who are using the same frequency.
The transceiver unmutes only when it receives the signal having the same
CTCSS tone or DCS code.
CTCSS and DCS do not make your conversation private or scrambled. It only
relieves you from listening to unwanted conversations.
Midland CT3000 instruction guide | 21