Publicidad
Idiomas disponibles
Idiomas disponibles
Chrysler 1994 and later vans with 3.8L V6 engine
Chrysler 1994 and later pickups with 8.0L V10 engine
Chrysler 1995 and later automobiles with 2.0L 4-cylinder, 2.4L 4-cylinder and 2.5L V6 engines
Chrysler 1998 & later automobiles with 2.7L DOHC V6, 3.2L SOHC V6 and 3.5L SOHC V6 engines
Mitsubishi Eclipse 1995-1999 with 2.0L DOHC 4-cylinder naturally aspirated engine
Pulley Removal
1. With drive belts removed from the pulley, use a ratchet and socket to remove the pulley center bolt. See figures 648616j and 648616k.
2. Select a pushrod from the kit that will bottom out in the hole in the end of the crankshaft and in the center bolt of the puller. In the tool case
these parts are labeled "Pushrod" and "Pulley Puller".
3. Note that the jaws of the puller must be able to lock behind the pulley. See figure 648616l. The pushrod must be the correct length for the
puller jaws to engage with the pulley.
4. Position the puller/pushrod assembly onto the pulley. Make sure the jaws of the puller are firmly engaged with the backside of the pulley. See
figure 648616m.
5. Place the jaws of an end wrench across the hex on the puller body and hold to keep from turning. Slowly turn the puller center bolt with a 3/8"
ratchet inserted into the square drive on the puller center bolt. See figure 648616n.
6. Keep turning the puller center bolt until the pulley is free of the end of the crankshaft. See figure 648616o.
Figure (j)
Figure (m)
2
Figure (k)
Figure (l)
Figure (n)
Figure (o)
Publicidad
