Brill 40 VB Manual De Instrucciones página 20

Fault
GB
Erratic running,
the implement vibrates strongly.
The blade shaft does not rotate.
Motor does not start.
Motor starts for a short time then
suddenly stops with a loud bang.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices (switch
handle, safety covers) and / or if
the cutting device is damaged or
worn. Never disable safety devices.
Check the work area before
starting work. Remove any foreign
bodies present (e.g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy shoes and
long trousers when working.
Never work barefoot or when
wearing only light sandals.
Warning! petrol is extremely
inflammable. Only keep petrol in
the container provided for the
purpose. Always fill the tank out-
doors and do not smoke when fill-
ing the tank with petrol. Fill up with
petrol before starting the engine.
Stop the engine before topping up.
20
Possible Cause
Blade shaft damaged
(out-of-balance),
fixture at the bearings loose.
Driving belt defective.
Driving belt slips.
Start button not pressed in.
Primer was not operated when
starting the motor.
No fuel, fuel tank empty.
Spark plug defective or
fuel tank empty.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Never open the tank cap or top
up with petrol whilst the engine is
running or the equipment is hot.
For safety reasons, do not attempt
to start the engine if the petrol has
overflowed. Instead, remove the
equipment from the area con-
taminated with petrol. Doe not
make any attempt whatsoever
to start the engine until all the
petrol vapours have evaporated.
For safety reasons, the petrol tank
and tank cap must be replaced if
damaged.
Always replace damaged exhaust
components.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools replaced
by Brill Service or your authorised
specialist dealer.
Remedy
Retighten the bearing screws.
Have damaged parts replaced
by the specialised workshop /
service station.
Contact specialist workshop /
service centre.
Readjust the belt tension.
Press start button.
Press the primer several times
(see Putting your Lawnmower into
Operation).
Clean spark plug and / or
fill the fuel tank.
Motor overhaul at specialist
workshop required.
A
Use / Responsibility
Make sure that there are no other
people (especially children) or
animals within or near the working
area.
Powered equipment can cause
serious injuries! You are responsible
for safety in the area where you
are working. Never start the equip-
ment whilst tilted – risk of injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Never permit the combustion
engine to run in enclosed spaces
where dangerous exhaust gases
can collect.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Ensure that you are standing
safely and on firm ground, even
on a slope.