Russell Hobbs 20330-56 Instrucciones página 109

diagrams
1 latch
~ steam button
2 handle
3 temperature control
4 thermostat light
5 soleplate
5 You may now carry the whole appliance by gripping the handle of the iron with one hand,
and putting the other hand underneath the base unit for support.
C WATER
6 Use tap-water – the anti-scale cartridge will soften the water.
7 If the-scale cartridge needs replacing, and you don't have a replacement, use distilled water
while you're waiting for the replacement.
9 Don't add anything to the water – you'll damage the iron.
V FILLING
10 Switch off (2), and unplug before filling.
the easy way
11 With the reservoir in place, pour water into the funnel in the rear of the base unit.
12 The bottom of the funnel feeds directly into the reservoir.
13 Fill the reservoir to the x mark.
14 Initialize the iron.
the other way
15 Reach under the end of the reservoir, raise the reservoir release, and slide the reservoir out of
the base unit.
16 Pour water into the hole in the top of the reservoir.
17 Fill the reservoir to the x mark.
18 Slide the reservoir into the base unit till the catch clicks into place.
19 Initialize the iron.
C SWITCH ON
20 Sit the iron on the base unit.
21 Check that the clamps are in the release position (press U).
22 Lift the iron off the base unit, unwind the steam pipe from its niche above the reservoir and
cable storage, then set the iron back on the base unit.
23 Open the cable storage ((), pull out the plug and all the cable, thread the cable through
the adjacent gap, and close the cable storage.
24 Put the plug into the power socket.
• The 2 button will blink red.
25 Press the 2 button to switch the appliance on.
• The 2 button will stop blinking and glow green.
• The r button will glow, to show that the boiler is operating.
• The S button will blink, to show that steam is being generated.
• The # light will glow
26 Press the S button to choose the steam level you want.
• The steam level lights are: S = low, ~ = medium, # = high.
27 When the S button glows steadily, the boiler is ready to make steam.
28 It'll then cycle on and off as the boiler works to maintain the temperature.
29 If the temperature control on the iron is set above room temperature, the thermostat light on
the iron will glow, to show that the soleplate is heating up.
6 steam pipe
7 funnel
8 clamps
9 boiler access knob
10 cable
11 cable storage
12 base unit
109
13 reservoir
14 reservoir lock
15 anti-scale cartridge
16 compartment
17 door
18 press to initialize
[