Noise And Vibration; Technical Specifications - Flex PXE 80 10.8-EC Instrucciones De Funcionamiento

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841. The
A evaluated noise level of the power tool is
typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value (when polishing
painted surfaces):
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
62841 and may be used to compare one tool
with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applications, with different accessories or poorly
maintained, the vibration emission may differ.
This may significantly increase the exposure
level over the total working period. For a precise
estimation of the vibration load the times should
also be considered during which the power tool
is switched off or even running, but not actually
in use. This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure above
85 dB(A).

Technical specifications

PXE 80 10.8-EC
Battery
Weight of
battery/kg
12
: 68 dB(A);
pA
: 79 dB(A);
WA
K = 3.0 dB.
: 6.53 m/s
h
K = 1.5 m/s
Polisher
AP AP
10.8/2.5 10.8/4.0 10.8/6.0
0.26 0.42
Average battery
life (depending
on speed, tool
diameter,
load ...)/min
Working
Temperature
Storage
Temperature
Charging
2
Temperature
2
Charger
Other specifications see figure
Overview (see figure A)
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Movable shield
2 Speed control button
– +/- function with 4 levels
– Level 1-3 "Polishing", Level 4 "spot sanding"
3 Switch
Switches the power tool on and off and also
accelerates it up to the preselected speed.
4 Gear head with handle cover
With air outlet and direction-of-rotation arrow.
5 Rating plate
6 Slot for battery
7 State of charge indicator
8 Release button for battery
9 Li-ion battery (2.5 Ah or 4.0 Ah or 6.0 Ah)
10 Backing plate
– 10/1 = polishing and sanding (velcro)
backing plat Ø75mm, can be combined
with drive types 11/2 and 11/3
– 10/2 = polishing and sanding (velcro)
backing plat Ø35mm, can be combined
with all types of drive.
– 10/3 = sanding backing plat Ø35mm
for (glue) spot sanding pads, can be
combined with all types of drive.
11 Drive types
AP
– 11/1 = rotary drive type, for polishing
and sanding, can not be combined with
the backing plate Ø75mm (10/1).
0.43
PXE 80 10.8-EC
20 35 50
-10~40℃
-40~70℃
5~40℃
CA 10.8/18.0
B