Maintenance And Care; Disposal Information; Declaration Of Conformity; Exemption From Liability - Flex PXE 80 10.8-EC Instrucciones De Funcionamiento

To continue working, switch the power tool off
and back on again.
NOTE
When the power tool is switched off, the tool
continues running briefly.
If using a polishing paste, use the respective tool
for each paste.
Sponges can be washed in the washing
machine.
For further information on the manufacturer's
products go to www.flex-tools.com.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool and grille in front of the
vent slots regularly. Frequency of cleaning
is dependent on the material and duration of
use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can be
found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing the
power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and Electronic
Equipment and transposition into national law
used electric power tools must be collected
separately and recycled in an environmentally
friendly manner.
Raw material recovery instead of
waste disposal.
14
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for recycling
according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!

-Declaration of Conformity

We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 62841 in accordance with the regulations
of the directives 2014/30/EU, 2006/42/EC,
2011/65/EU.
Responsible for technical documents: FLEX-
Elektrowerkzeuge GmbH, R & D Bahnhofstrasse
15, D-71711 Steinheim/Murr
04.15.2019; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and his representative are
not liable for any damage and lost profit due to
interruption in business caused by the product
or by an unusable product. The manufacturer
and his representative are not liable for any
damage which was caused by improper use of
the power tool or by use of the power tool with
products from other manufacturers.
PXE 80 10.8-EC