geberit Sigma 80 Manual Del Usuario página 16

Settings
D - Activating or deactivating the automatic
flush actuation
When the automatic flush actuation is activated, the WC
flush control always activates a flush when you step
back. Manual actuation is not necessary.
Setting 1 = deactivated
Setting 2 = activated
Prerequisites
The WC flush control is ready for operation.
If the sensors are not covered at the same time, a
flush will be activated. Remove your hands and
repeat the procedure.
1
Cover both sensors at the same time with both
hands at a distance of approx. 5 cm. After a few
seconds both sensors begin to flash. After a few
more seconds, the sensors flash red 3 times and
then turn blue. Now remove both hands.
2 Cover the sensor on the left with your hand until it
lights up orange. The sensor on the right flashes.
3
Cover the sensor on the left with your hand again
until it lights up yellow. The sensor on the right
flashes repeatedly to show the current setting 1.
or 2. (setting 1 = flashing once,
setting 2 = flashing twice).
Result
You are now in the setting mode for automatic
flush actuation.
16
All manuals and user guides at all-guides.com
4
Cover the sensor on the right repeatedly until the
desired setting has been made. Each time the
sensor is covered, the WC flush control changes
between the two settings (1-2-1-2- ...).
5 Cover both sensors at the same time with both
hands at a distance of approx. 5 cm until both
sensors flash once.
Result
The desired setting is now saved. The WC flush
control is ready for operation again.
E - Resetting to factory setting
The settings B, C and D are reset to the factory setting,
see Overview.
Prerequisites
The WC flush control is ready for operation.
Cover the sensor on the left for half a minute until
both sensors light up red. A flush is then triggered.
Result
The factory settings are restored.