AKG DMS700 Modo De Empleo página 2

DMS
700
Thank you
Symbols Used
L
Important Note!
!
2
for purchasing an AKG product. This manual contains important instructions for setting up and op-
erating your equipment. Please take a few minutes to read the instructions below carefully be-
fore operating the equipment. Please keep the manual for future reference. We hope you enjoy
using your system!
L
The lightning flash with arrowpoint in an equilateral triangle means that there are dan-
gerous voltages present within the unit.
L
The exclamation point in an equilateral triangle on the equipment indicates that it is nec-
!
essary for the user to refer to the User Manual. In the User Manual, this symbol marks in-
structions that the user must follow to ensure safe operation of the equipment.
• AKG continually improves the internal firmware of the DMS 700 system in order to meet
changing customer needs in the best possible way. Should your system use a different
firmware version than the one described in this user manual, some functions may differ
from the related instructions.
• To find out the actual firmware version implemented in your system, please check the
menu. The firmware version described in this user manual is stated on the cover page.
• Before you read on, we recommend comparing the receiver firmware version against
the version described in the manual. If the two versions are not identical, please visit
www.akg.com to find out about the latest changes.
The DHT 700 D5, DHT 700 C5, and DPT 700 have been tested and found to comply with the lim-
its for a low-power auxiliary station pursuant to Part 74 of the FCC Rules. The DSR 700 has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful in-
terference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or tel-
evision reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the follow ing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connect ed.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
regulations.
Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's
authority to operate this equipment.
The DRS 700 complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
inter ference receiv ed, including interference that may cause undesired operation.
FCC Statement