GE Profile PV977 Manual Del Propietario E Instrucciones De Instalación página 18

INSTALLATION - VENTED TO THE OUTSIDE
STEP 8: INSTALL VERTICAL
SUPPORTS
screws. Make sure all screws are securely tightened.
A
B
A. 4 - Lower vertical supports
Installation Instructions
STEP 9: CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure
to use U.L. approved anti-oxidant compound and
aluminum-to-copper connectors.
and the knockout on the top left side.
Knockout
Junction
box cover
strain relief (not provided).
Connect the white lead to the branch circuit
white lead.
lead.
circuit green lead or bare ground lead.
electrical connector.
the cover. Be sure the wires are not pinched.
screws.
(Cont.)
49-2000915 Rev. 0