Flex BME 8-4 Instrucciones De Funcionamiento Originales página 29

TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Attach the handle
Attach the auxiliary handle to the thread in

position 1 or 2.
Adjusting the belt run
Adjust the belt run using the front screw on

the sanding arm. While the belt is running,
select the setting so that the belt runs in the
centre of the pressure roller.
Changing the sanding arm
To change the sanding arm, loosen the

three fastening screws.
Remove sanding arm.

Attach new sanding arm using the three

screws.
Operating instructions
NOTE
When the electric power tool is switched off,
it continues running briefly.
Sanding
When the locking screw (1.) is undone, the

swivel arm can be tilted up to 140° (2.).
As a result, the belt file can also be used
for surfaces which are difficult to access,
e.g. the insides of pipes.
Vary the removal rate via the contact

pressure. Ensure that the contact pressure
is even and not too heavy. If the contact
pressure is too high, the sanding belt may
slip off the roller.
Switching on and off
Brief operation without engaged switch
Push the switch rocker forwards and hold

in position.
To switch off the power tool, release

the switch rocker.
29