Publicidad
Idiomas disponibles
Idiomas disponibles
Continuous operation with engaged
switch
Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
To switch off the power tool, release
the switch rocker by pressing the rear end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Preselecting the speed
The adjusting wheel enables the operating
speed to be continuously adapted to the
material requirements.
Speed
Belt speed belt sander
burnishing
attachment
attachment
Belt grinder attachment
[r.p.m.]
[m/s]
1
1300
30
2.7
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Speed
Belt speed belt sander
burnishing
attachment
attachment
Belt grinder attachment
[r.p.m.]
[m/s]
2
1600
3
2300
4
3000
5
3500
6
3900
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
WARNING!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing. Impairment of
the protective insulation! Operate the power
tool via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and ventila-
tion slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The drive unit is fitted with cut-off carbon
brushes. When the cut-off carbon brushes
reach their wear limit, the power tool switches
off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the car-
bon brushes can be seen sparking through
the rear air inlet apertures. If the carbon
brushes are sparking excessively, switch off
the power tool immediately. Take the drive
unit to a customer service centre authorised
by the manufacturer.
3.3
4.7
6.3
7.4
8.1
Publicidad
Capítulos
