Instructions For Use - Flex BME 8-4 Instrucciones De Funcionamiento Originales

TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4

Instructions for use

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power tool
Unpack the drive unit and attachments, and
check that no parts are missing or were
damaged during transport.
Mounting attachments
Place the required attachment on a level

work surface with the snap coupling facing
upwards.
Open the clamping lever on the

attachment (1.).
Place the drive unit in the required position

to the attachment and press down until it
audibly engages (2.).
Close the clamping lever (3.).

NOTE
The gear teeth in the snap coupling of the
drive unit and the attachment are automati-
cally interlocked when the machine is
switched on.
Removal of attachments
Open the clamping lever on the attach-

ment (1.).
Press and hold down the release lever (2.).

Lift the drive unit off the attachment (3.).

Loosen locking bolt on attachment (1.).

Push and hold down release lever (2.).

Lift up attachment (3.).

25