Using Ttl Flash Control With The J1, J2, J3, And S1 - Nikon SB-N10 Manual Del Usuario

Using TTL Flash Control with the J1, J2, J3, and S1

❚❚
Follow the steps below to take pictures in TTL fl ash control mode.
1 Adjust camera settings.
Adjust camera settings as follows.
• Shooting mode: Choose programmed
auto (P), shutter-priority auto (S), ap-
erture-priority auto (A), or manual (M).
• Flash mode: Choose a setting that disables red-eye reduc-
tion and ensures that the fl ash will fi re with every shot.
En
2 Set the fl ash unit to TTL.
Rotate the mode dial to TTL and
confi rm that the fl ash-ready lamp is
lit blue. If it is not, keep the target-
ing lamp button pressed until the
lamp lights blue (about three sec-
onds) to show that fl ash-compen-
sation support is disabled (
3 Take pictures.
24
0
5).