Install The Door - Kohler K-1913 Guia De Instalacion

1
Align rollers on drain
side and swing door
in on an angle.
Latch Pin
Strike Plate
Track for
Pulley Assembly

14. Install the Door

Installations Requiring Reassembly Only
NOTE: These steps are not required if the door was not removed in a previous step. If the door was not
removed, proceed to the "Attach the Counterweights" section.
Align the door and rollers on the drain side of the bath.
Pivot the other side of the door inward until the latch pins engage on both sides of the door.
Have the second installer hold the door up and brace it with a 2x4 under the door, with the bottom
end of the 2x4 positioned on the subfloor (not the receptor tray).
Slide the roller assembly up and partially into the door from below, making sure to feed the door
power cord back into the door.
If the bracket was removed, reattach it to the roller assembly.
Reconnect the power cord to the door, then slide the roller assembly all the way up into the door.
If it is difficult to move the roller assembly into place, apply a small amount of lubricant to the faces
of the roller assembly. If necessary loosen the blue mounting bracket screws on one or both sides.
Retighten the blue screws when the roller assembly is in place.
Reinstall the cover plate on the base of the door and secure with the screw(s) previously removed.
1128532-2-G
2
Drain End
Top View
Proper Roller Alignment
Swing other end of door
in place and latch.
Mounting Bracket
Lubricate if necessary.
26
Reconnect door
power cord.
Bottom View
Attach screws.
Install roller assembly.
Kohler Co.