Declaration Of Conformity - Würth 0714 556 24 Instrucciones Para El Manejo

BEG - book.book Seite 11 Mittwoch, 8. Februar 2006 9:31 09
Removal of the Control Unit
If the customer service determines that the unit has a de-
fect by remote diagnosis, only the control unit must be
sent in and the repaired or borrowed control unit rein-
stalled.
Important! The removal and reinstallation may be per-
formed only by a specialist.
Control unit removal:
1. Loosen and remove the handle of the unit.
2. Loosen the two screws underneath the electronics
housing .
3. Then slide the electronics housing forwards and re-
move it from the cart. When doing this, make sure
that the earthing plug is removed from the cart.
The installation of the control unit takes place in the re-
verse order.
Warranty
For this Würth tool, we provide a warranty in accord-
ance with statutory/country-specific regulations from
the date of purchase (proof of purchase by invoice or
delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can be recognised only when the tool is present-
ed undisassembled to a Würth branch office or a Würth
field service employee.

Declaration of conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 292, EN 60204-1, EN 61000-6-2, EN 61000-6-4
according to
73/23/EEC, 89/336/EEC, 98/37/EC.
05
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
the provisions of the regulations
R. Bauer
11