Cylinder Stops
The cylinder stops ensure the same cutting height after
raising the deck to clear an obstacle. The stops are
stored on a post under the operator's right leg. The stops
are supplied in two (2) sizes. The thinner stops change
the cutting height by 1/4" (.64 cm). The thicker stops
change the cutting height by 1/2" (1.27 cm).
1. Remove the cylinder stops from the post and snap
onto the lift cylinder rod.
2. Push the lift lever forward until the cylinder rests
against the cylinder stops.
Fuel Shut-Off Valve
This valve is used to control the flow of
OFF
LEFT
fuel leaving the fuel tanks. The valve
TANK
must be open for the engine to operate.
RIGHT
TANK
It should be turned to "OFF" if the unit
OF1880
is to be stored for extended periods. It
is also used to select which fuel tank the engine will draw
fuel from, right or left.
Parking Brake Lever
1. Pull lever up to engage parking brake.
2. Push lever down to disengage parking
brake.
OF1740
Seat Adjustments
WARNING: Make all seat adjustments with unit
stationary, parking brake on and engine shut off.
To adjust seat forward or backward:
1. While seated, pull seat adjustment lever toward
center and slide seat into desired position.
2. Release lever and slide seat forward or back to lock
seat into position.
Engine Oil Pressure Indicator
(Optional)
This will light up "Red" if the oil pressure is
low. Check oil level and add if necessary.
OG0601
Refer to engine manual.
Hour Meter (Optional)
Hour Meter operates when Ignition
Switch is in the "Run" position and
records actual time engine operates.
IMPORTANT: Keep a record of Hour
Meter readings for recommended
Lubrication and Maintenance intervals.
NOTE: For accurate readings be sure Ignition Switch is
OFF when tractor is not in operation.
FILLING FUEL TANK
WARNING: AVOID INJURY. Read and
understand Safety Rules in Safety Section
before proceeding.
Add fuel to Fuel Tank as needed. See your Engine
Manual for correct type and grade of fuel.
To add fuel to the fuel tank:
1. Refuel the unit only in a well ventilated open area.
2. Stop the engine.
3. Clean the fuel cap and the area around the fuel cap
to prevent dirt from entering the fuel tank. Remove
the cap from the fuel tank.
4. Fill the fuel tank. Be careful not to spill the fuel. Do
not overfill, allow for fuel expansion. Stop filling when
fuel is about 1" below the bottom of the neck.
5. Install the cap on the fuel tanks and tighten.
6. Clean up any spilled fuel before starting the engine.
STOPPING IN AN EMERGENCY
The unit can be stopped immediately at any time by
turning the ignition key to the "Off" position.
STARTING AND SHUT OFF
CAUTION: Read entire Owner/Operator
Manual, Clutch Manual, and Engine Manual
first.
DO NOT attempt to start engine at this time.
To start the engine:
1. Make sure the control levers are in the neutral
position.
2. Put the PTO switch in the "Off" position.
3. Set Parking Brake.
4. If the engine is cold, move the choke control to the
"On" position. If the engine is warm or hot, do not use
choke.
5. Move the throttle to 3/4 "Fast" position. See Engine
Manual for detailed instructions.
6. Put the ignition key in the switch and turn it to the
"Start" position.
7. As soon as the engine starts, release the key and
move the choke control to the "Off" position from the
"Choke" position. Wait until the engine is running
smoothly before operation.
To stop the engine:
1. Bring the steering control levers to neutral.
Disengage the PTO and set the parking brake.
2. Move the throttle lever to the "Slow" position.
3. Turn the ignition key to the "Off" position.
GB - 11