Maintenance Schedule - Ariens Zoom 2250 Manual Del Usuario

working conditions (heavy loads, high ambient
temperatures, dusty conditions, or airborne debris). See
the maintenance instructions in the Engine Manual for
additional information
.

MAINTENANCE SCHEDULE

Each
Service Performed
Use
•
Engine Oil
Safety
•
Interlock
System
•
Air Cleaner
•
Hydraulic
Fluid
•
Blades
•
Tires
Battery and
Battery
Fluid
Engine Oil
Fasteners
All Belts
Fuel Filter
Hydraulic filter
&oil
ENGINE
Correct maintenance can increase the life of the engine.
See your engine manual for information on the operation
and maintenance of your engine.
1. Before each use, check the level of the oil in the
engine. Never operate the engine when the oil level is
below the add mark.
2. Each day before operating, check the air cleaner
element. Dirt can decrease the flow of air to the
engine.
3. Each day before operating, check the air cooling
system on the engine. Debris can decrease the flow
of air cooling the engine.
4. Follow the maintenance instructions in your engine
manual concerning oil changes and engine coolant
changes.
10 25 50 100 500
•
•
•
•
•
TIRES
Before each use make a visual check of tires. The correct
air pressure is 12-15 psi (83-103 kN/m
and 20-25 psi (138-172 kN/m
LUBRICATION
IMPORTANT: Wipe each fitting clean before and after
lubrication.
Steering system and Speed Selector components should
be lubricated every 50 hours of operation or every
3 months whichever comes first. (Figure 10)
Lube fitting locations are:
– caster pivot (2)
– front axle pivot (1)
Apply Stens Mix Hi-Temp Grease or equivalent to the
lube fittings. Order P/N: 00036700 - ten pack of 14 oz.
cartridges.
When using Stens Mix Grease for the first time, all
components should be thoroughly cleaned prior to
lubricating.
Apply oil at all pivot points and pin connections.
1
2
•
1
LUBRICATION
REF
GREASE
1
GREASE
2
OIL
FASTENERS
Before each use, check mower blade mounting hardware
and all other fasteners. Replace fasteners that are
missing or damaged. Tighten all nuts and bolts to their
correct torque value.
GB - 13
2
) for the rear tires
2
) for the front tires.
QTY DESCRIPTION/
INTERVAL
LOCATION
2 CASTER PIVOT 400 Hrs
1 AXLE PIVOT 50 Hrs
ALL PIVOT POINTS, 50 Hrs
PIN CONNECTIONS
Figure 10
OF1792
REF
1
2