Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicles tailgate
and remove each of the tail light
housing assemblies (Fig. 1A)
by removing the screws on each
housing.
3. Starting on the left (drivers)
side of the vehicle, route the
T-Connectors black box and the
connectors with the yellow and brown
wires up through the access hole at the
rear corner of the vehicle and out through the tail light opening (Fig. 1B).
4. Starting on the left (drivers) side, Locate the wiring harness connectors
leading to the rear of the tail light housings. They will be similar in design to
those on the T-Connector harnes. Disconnect the connector from the tail light
harness by pressing on the connectors locking tabs and carefully pulling the
connectors apart. Insert the T-Connector ends containing the yellow wires
between these seperated ends, ensuring that the locking tabs engage.
Caution : Take care not to damage any locking tabs.
5. Locate a clean accessible mounting location on the vehicle near the wiring
harness ends within reach of the white wire and grounding eyelet and drill a
3/32" hole.
Caution: Take care not to drill through the body or any exposed
surface.
6. Mount the white wire using the ground screw and eyelet provided.
7. Route the remainder of the T-Connector assembly to the right (passenger)
side of the vehicle and up through the right side tail light opening.
8. Separate the connectors from the passenger side tail light harness and
insert the T-Connector ends with the green and red wires between the
seperated ends.
A
B
Fig. 1
Publicidad
