Use
2.4. HOW TO PUT ON treeMOTION USCA
Check that the waist belt and leg loop
buckles are undone (1, 9)
pic. 2
a) Hold the
harness by the
back support
c) Securely close
the waist belt
buckle (1)
2.5. ... AND OBTAIN A GOOD FIT
1) Adjust waist belt webbing (1) and
stow the end under the elastic loop.
2) Adjust webbing in each leg loop (17)
and stow the end under the elastic
loops.
3) Adjust webbing in the adjustable
links (5) and stow the end under the
elastic loops
10
b) Step inside
the rope bridge
(10) and the leg
loops (17)
pic. 4
d) Securely close
the leg loop
buckles (9)
I
II III
III
II
pic. 6
pic. 3
IV
pic. 7
4) Adjust the length of the rope bridge
pic. 5
(10) ensuring the stopper knots are
properly tied, dressed and set be-
fore going 'on rope'
The climber shall fully equip the har-
ness for the task to be performed, then
hang in suspension and adopt a range
of work positions to ensure that the
harness is properly fitted, comfortable
and suitable for the task. Leg and back
paddings are attached to the harness
by hook-and-loop fastener and can be
removed for cleaning and put back in
place.
I
III
II