How The Statusdisplay™ Works - Jabra BT2080 Manual Del Usuario

Tabla de contenido

Publicidad

Mute/un-mute
- to mute, press both volume up and down at the same time .
a low beep alert plays during a muted call .
- to un-mute, tap either of the volume buttons .
Call waiting and placing a call on hold*
- this lets you put a call on hold during a conversation and
answer a waiting call .
- Press the answer/end button once to put the active call on hold
and answer the waiting call .
- Press the answer/end button to switch between the two calls .
- tap the answer/end button to end the active conversation .
HoW tHe stAtUsDIsPLAY™ WoRKs
bluetooth
Indicator
battery
Indicator
to save battery the Jabra StatusDisplay™ is turned off after 3 seconds .
Get an instant status from the Jabra StatusDisplay™ by a tap on
any button on the headset when you are not on a call .
* Phone dependent
Indicates if your headset is connected to your
phone
- Solid light means headset is connected to your
phone
- Flashing light means headset is in 'pairing
mode' and ready to be connected to a new
phone
Indicates battery level and if headset is
turned ON
- Green light indicates that the headset has more
than 10 minutes of talk time remaining
- red light indicates that the headset has less
than 10 minutes of talk time remaining
Jabra bt2080
7

Publicidad

Tabla de contenido
loading

Tabla de contenido