Safety Instructions - Flex CS 60 WET Manual De Instrucciones

CS 60 WET

Safety instructions

WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries . Keep all safety instructions and
other instructions in a safe place for the
future.
Always use the guard hood supplied with

the electric power tool. The guard hood
must be attached securely to the electric
power tool and adjusted to ensure maxi-
mum safety, i.e. the operator is exposed
to the smallest possible part of the inser-
tion tool. Ensure that you and anybody
in the vicinity remain outside the plane
of the rotating insertion tool. The guard
hood is intended to protect the operator
from fragments and accidental contact
with the insertion tool.
Use only diamond-tipped cutting-off

wheels which were designed and recom-
mended by the manufacturer especially
for this electric power tool. Just because
you can attach the accessory to your
electric power tool does not guarantee
safe use.
The permitted speed of the cutting-off wheel

must be at least as high as the maximum
speed indicated on the electric power tool.
An accessory which rotates faster than
permitted may shatter and fly off.
Cutting-off wheels may be used for

the recommended applications only.
For example: Never grind with the side
area of a diamond-tipped cutting-off wheel.
Diamond-tipped cutting-off wheels
are designed for peripheral grinding.
If a lateral force is applied to these tools,
they may shatter.
Always use undamaged clamping

flanges in the correct size and shape for
the insertion tool you have selected.
Suitable flanges support the insertion
tools and therefore reduce the risk of a
break.
Do not use worn cutting-off wheels from

larger electric power tools. Insertion tools
for larger electric power tools are not
designed for the higher speeds of smaller
electric power tools and may break.
Outer diameter and thickness of the

insertion tool must correspond to the
dimensions of the electric power tool.
Incorrectly measured insertion tools
cannot be adequately shielded or
controlled.
The bores of the cutting-off wheels and

clamping flanges must exactly match
the grinding spindle of your electric
power tool. Insertion tools, which do not
fit exactly on the grinding spindle of the
electric power tool, rotate unevenly,
vibrate violently and may result in loss of
control.
Do not use any damaged insertion tools.

Before use, always check the insertion
tools for splinters and cracks.
If the electric power tool or the insertion
tool is dropped, check for damage
or use an undamaged insertion tool.
When you have checked and inserted
the tool, ensure that you and anybody
in the vicinity remain outside the plane
of the rotating insertion tool and leave
the power tool running for one minute
at maximum speed. Damaged insertion
tools usually break during this test time.
Wear personal protective equipment.

Depending on the application, wear
full face protection, eye protection
or goggles. If appropriate, wear a dust
mask, hearing protection, protective
gloves and/or a special apron which
protect you from small sanding and
material particles. You should protect
your eyes from foreign objects which are
ejected for different applications. Dust
and respirator masks must filter the dust
which is generated by the power tool for
the particular application. If you are
exposed to loud noise for a prolonged
period, you may suffer hearing loss.
17