Maintenance And Care; Spare Parts And Accessories; Disposal Information - Flex CS 60 WET Manual De Instrucciones

CS 60 WET
Using the guide rail
NOTE
When placing the saw on the guide rail,
always use the guide grooves.
Inner guide groove at mitre angle of 0°
Outer guide groove at mitre angle set > 0°

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning the electric power tool
WARNING!
Do not use water or liquid detergents.
Regularly blow out the housing interior

and motor with dry compressed air.
At the end of work immediately remove

abrasion-water mixture to prevent it from
drying and becoming encrusted.
When changing the diamond-tipped

cutting-off wheel, clean the interior
of the guard hood.
Also clean the guide rail, otherwise

the saw will not be guided properly
resulting in an inaccurate cut.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the motor housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.

Spare parts and accessories

Other accessories, in particular insertion tools,
can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!
27