Maintenance And Care - Flex MS 1706 FR Instrucciones De Funcionamiento

MS 1706 FR
– Pull up the release handle (6.) and
swivel the motor unit as far as it will
go.
– The release handle must engage in
the new position.
The user can now adopt an
ergonomically favourable posture when
making a drawing cut.
Operating instructions
To make vertical cuts, swivel the motor
unit as described previously.
Place the machine above and pull
downwards.
Your right hand guides the motor unit,
your left hand pulls on the handle (7.).
To make horizontal cuts, push the
power tool.
Your right hand guides the motor unit,
your left hand is placed on the handle/
intake flange (4.)
Tips
When making cuts in a very hard
material, the diamond cutting disc may
overheat and be damaged.
– Immediately stop cutting and leave
the cutting disc to cool down at no-
load speed.
A spark ring around the cutting disc and
a decreasing cutting rate are signs of a
blunt cutting disc.
– Short cuts in abrasive materials, e.g.
the sharpening stone for diamond
tools in the range of accessories,
sharpen the cutting disc.
– If this does not improve the cutting
performance, replace the cutting
discs.

Maintenance and care

DANGER
Before performing any work on the wall
chaser, pull out the mains plug.
Cleaning
Regularly clean the power tool and
ventilation slots. Frequency of cleaning
Instruction manual
13