Parkside PAFS 550 A1 Traducción Del Manual De Instrucciones Original página 17

ATTENTION!
► If you are using a metal container, earth the
paint spray gun 7 beforehand .
♦ Release the trigger 9 as soon as the cleaning
fluid starts flowing out .
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible .
♦ Turn the function switch e to the vertical
position (PRIME) .
♦ Unlock the paint spray gun 7 by turning the
safety catch 6 so that its tip is facing down .
♦ Drain off the remaining paint by pulling the
trigger 9 . Hold the paint spray gun 7 over
the detergent container while doing so .
♦ Release the trigger 9 as soon as clear cleaning
fluid starts flowing out .
♦ Lock the paint spray gun 7 by turning the safety
catch 6 with the tip as far back and up as
possible .
♦ Turn the pressure regulator dial 3 to position 0
(off) . Remove the plug from the mains socket .
♦ Depressurise the appliance .
♦ Remove the high-pressure hose w from the
paint spray gun 7 with the aid of an adjustable
spanner .
♦ Disassemble the nozzle holder a along with
the nozzle 5, holder o and plastic ring i
(see fig . F) . Clean all parts thoroughly using
suitable cleaning agents .
♦ Lock the paint spray gun 7 by turning the safe-
ty catch 6 with the tip as far back and up as
possible .
NOTE
► Clean the HEA filters q regularly . Replace
them if cleaning is no longer sufficient .
♦ Disconnect the suction hose 2 and the return
hose 1 from the appliance using the hose
clips l . Clean the outsides of the hoses .
PAFS 550 A1
♦ Remove the filter plate u of the intake filter t
(see fig . E) .
♦ Clean the filter plate u thoroughly under
running water .
♦ Remove the high-pressure hose w from the
connecting thread r using an adjustable
spanner . Counter the connection thread r
using a second adjustable spanner .
♦ Dip the inlet valve h into a container filled with
conservation agent (e .g . fine mechanical oil)
so that the fluid can be sucked up .
♦ Insert the plug into a mains power socket .
♦ Hold a cloth in front of the connecting
thread r . Turn the pressure regulator dial 3
to position 1 for about 5 seconds . This helps
to preserve the appliance . Turn the pressure
regulator dial 3 to position 0 (off) .
♦ Remove the plug from the mains socket .
GB │ IE │ 13 ■