List Of Figures; List Of Tables - 3M 740 Serie Instrucciones De Uso

Brand
M
™
Duracell
®
Duracell
®
Energizer
®
Energizer
®
Energizer
®
Duracell and Coppertop are registered trademarks of Procter and Gamble. Energizer, Max and e

LIST OF FIGURES

1 - 70 Series Detector Features
 - Turning On the Unit
 - Turning Off the Unit
 - User ID
5 - Date and Time
6 - Explosive Gas Selection
7 - Oxygen Low Alarm Level Set Point
8 - High Alarm Level Set Point
9 - STEL Alarm Level Set Point
10 - TWA Alarm Level Setpoint
11 - STEL/TWA Diplay Option
1 - Latched Alarm Option
1 - Test Gas Concentration Setting
1 - Sensor Test Interval Setting
15 - Backlight Duration Setting
16 - Confidence Beep Option
17 - Data Logging Option
18 - Password Setting
19 - Peak Values
0 - Clearing Peaks

LIST OF TABLES

1 - Default Alarm Set Points
 - Factory Default Calibration Gas Settings
 - Approved Alkaline Batteries for the M 70 Series Detector
OPERATING INSTRUCTIONS
The following instructions are intended to serve as a guideline for the use of the M
intended to replace the policy and procedures for each facility.
This instrument helps monitor for the presence and concentration level of certain specified airborne gases. Misuse may produce an inaccurate reading which means
that higher levels of the gas being monitored may be present and could result in overexposure and cause sickness or death . For instruments with an oxygen sensor
installed, misuse may produce an inaccurate reading where lower or higher levels of oxygen may be present and cause sickness or death . For proper use, see
supervisor or User Instructions, or call M in U.S.A., 1-800--60. In Canada, call Technical Service at 1-800-67-1.
Each person using this equipment must read and understand the information in these User Instructions before use. Use of this equipment by untrained or unqualified
persons, or use that is not in accordance with these User Instructions, may adversely affect product performance and result in sickness or death.
Use only for monitoring the gas which the sensor and instrument are designed to monitor. Failure to do so may result in exposures to gases not detectable and cause
sickness or death . For proper use, see supervisor or User Instructions, or call M in U.S.A., 1-800--60. In Canada, call Technical Service at 1-800-67-1.
If you have any doubts about the applicability of the equipment to your job situation, consult an industrial hygienist or call M's Occupational Health and Environmental
Safety Division Technical Service Department at 1-800--60. In Canada, call Technical Service at 1-800-67-1.
Each time the unit is turned on, it performs a self-test, which activates the audible, vibratory and visual alarms. If the self-test fails, or all the alarms do not activate, do
not use. Failure to do so may adversely affect product performance and result in sickness or death.
CSA Approved Batteries for the 3M
Type
Lithium-ion
Alkaline
Alkaline
Alkaline
Alkaline
Alkaline
 are registered trademarks of Energizer Holdings, Inc.

7
7
7
7
7
7
8
8
8
8
8
8
9
9
9
9
9
9
9
10
11
1
740 Series Detector
™
Model Name
Lithium-ion Battery
Ultra
Coppertop
®
Industrial
Max
®
e
®
1 - Gas Alarm
 - STEL Alarm
 - Low Battery Alarm
 - Low Battery Warning
5 - Sensor Test Countdown
6 - Zeroing the Sensors
7 - Sensor Test
8 - Attaching the Gas Test Hood
9 - Waiting for Gas
0 - Sensor Test
1 -Test Successful
 - Recharging
 - Replacing the Li-ion Battery
 - Replacing the Alkaline Batteries
5 - 70 Series Detector Data Manager Software Program
6 - Sensor Pack Screws
7 - Removing Sensor Pack
8 - Zebra Strip
9 - Replacing the Sensor Filter
 - Typical Data Log Header
5 - Data Log Codes
Multi-Gas Detector 70 Series. It is not to be considered all-inclusive, nor is it
™
WARNING
WARNING
7
Model Number
91-00-01
MX00
MN00
EN9
E9
X9
10
10
10
11
11
1
1
1
1
1
1
1
1
1
1
16
16
16
16
1
15