Omnifilter K2 Manual Del Propietário página 2

INSTALLATION
INSTRUCTIONS ON 3/8"
COPPER TUBING USING THE
OMNI SINK KIT:
There are many ways to install your
OMNI Under-Sink Water Filter into a
water line. These instructions are for
use with the Omni Sink Kit.
1. Locate and turn off the main water supply
valve and open a faucet to drain the system.
See Figure 1.
Locate and
close the
cold water
inlet valve
3" minimum vertical
clearance required
Figure 1
2. Position the filter housing bracket on the wall
of the cabinet nearest the cold water line
beneath the sink. Leave a 3-inch minimum
clearance between the bottom of the filter
housing and the floor of the cabinet. Use a
pencil to mark the bracket slots on the wall.
Figure 2
4200 0602
poly tubing
bracket
3/8" to 3/4"
compression fitting
brass nuts
brass inserts
brass union
brass ferrules
plastic insert
screws
3. Drill a 1/8-inch hole at each of the two marks,
install the drywall anchors (can be purchased
locally) and insert the mounting screws. Leave
each screw head 1/4" out from the wall.
4. Empty the OMNI SINK-KIT box and identify all
of the components. See Figure 2.
5. Attach the mounting bracket to the filter
head. See Figure 3.
Bracket
3/8" to 3/4"
Threaded
Compression
Fitting
Figure 3
6. Install one of the threaded compression fit-
tings into the "In" port of the filter head and
one into the "Out" port of the filter head.
Tighten the fittings with a wrench.
NOTICE: The poly tubing will wear with time.
Replace tubing if necessary. The "IN" and
"OUT" ports are marked on the top of the
filter head.
7. Cut the cold water line with a tube cutter and
gently bend and separate the water lines. See
Figure 4.
8. Attach the brass unions to the cut copper lines:
Cut and gently bend
the copper water line.
Figure 4
2
"Head" Portion
of Filter Housing
"Sump" Portion
of Filter Housing
3708 0600 OM 637
4148 0202 OM 637