Technical Data - Vetus Magnus Manual De Manejo Y Instrucciones De Instalación

- Glass-fibre reinforced polyester; use self-tapping panel
screws, 4.2 mm diameter.
- Steel; use M5 nuts and screws.
4. Tighten screws evenly until sealant just starting to be
squeezed out from between the hatch and the deck.
5. Clean of excess sealant and allow to set.
6. Fully tighten all mounting screws once sealant has set.
Maintenance
Clean the anodized or powder-coated aluminium profiles regu-
larly; 2 to 4 times a year, depending on how dirty they get.
Use only neutral cleaning agents. Do NOT use alkaline, acid
and/or abrasive cleaners.
After cleaning, apply a thin coat of transparent wax for protec-
tion.
Protect the sealing rubbers with talcum powder.
Magnus Hatches
Re-adjusting the hinges:
Adjust the hinges, with a 10mm socket, if the hatch will not
remain in the open position, see Drawing 7.
1 Remove this screw in order to be able to fully open the
hatch during assembly.
2 Loosen the lock nut prior to opening or closing the
hatch.
The panel can open to 120 degrees.
ALTUS
vetus® Hatches
2
1

Technical Data

Magnus:
Deck frame, hatch frame: Aluminium (6060) Window: PMMA
10 mm
Magnus hatches can be opened to a maximum of 200
degrees.
Altus:
Deck frame, hatch frame: Aluminium (6060) Window: PMMA
10 mm
Altus hatches can be opened to a maximum of 120 degrees
This panel can open to 180 degrees.
MAGNUS
ENGLISH
5
070109.01