Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
General
DO NOT install this child restraint under the following conditions:
• Vehicle seats with lap belt.
• Vehicle seats facing sideward or rearward with respect to the
running direction of the vehicle.
• Vehicle seats movable during installation.
This is an i-Size universal ISOFIX enhanced child restraint
system. It is approved according to Regulation 129/02, for use in
an i-Size compatible vehicle seating position. It will fit vehicles
with positions approved as ISOFIX positions (as detailed in the
vehicle handbook), depending on the category of the child
restraint and of the fixture. If in doubt, consult either the child
restraint manufacturer or vehicle manufacturer.
Read all the instructions in this manual before using this product.
If you have any further questions. If in doubt, please consult the
child restraint manufacturer or the retailer.
The mass group and the ISOFIX size class for which this device is
intended is: Group 1, B1 and C; Group 0+, C.
Concerns on Installation
DO NOT install this child restraint on vehicle seats with Lap Belts
and 3-point Retractor Safety Belt (Fig. 2 & Fig. 3).
This child restraint is suitable for vehicle seats with ISOFIX
anchor points with the Base (Fig. 4).
DO NOT install this child restraint on vehicle seats that face
sideways or rearward with respect to the moving direction of the
vehicle (Fig. 5.1).
DO NOT place rear-facing child restraint on front seat with air bag
(Fig. 5.2), death or serious injury may occur. Please reference
vehicle owner's manual for more information.
It is recommended to install this child restraint on the rear vehicle
seat, facing rearwards (Fig. 5.3).
Installation of ISOFIX System
• Unfold the Support leg from the base (Fig. 6).
• After placing the base on the vehicle seat, extend the Support
leg to floor (Fig. 7), when the Support leg indicator shows green
means it is installed correctly (Fig. 8).
Make sure the Support leg is fully contact with the vehicle floor
pan. Squeeze the Support leg releasing button, then shorten
the Support leg upwards.
• Press the ISOFIX Pop-up Triggers on two sides and the ISOFIX
connectors will be popup (Fig. 9).
• Make the ISOFIX connectors face the ISOFIX anchorage
system between the seat and the backrest of the vehicle seat
(Fig. 10).
• Click the child seat ISOFIX connectors into the ISOFIX
anchorage system. When clicking in (Fig. 11), the indicators
informing you about the correct installation, should be green
(Fig. 11.1) and your child restraint's backrest is aligned parallel
(Fig. 11) with the backrest of the vehicle seat.
ISOFIX
Publicidad
